Greene Concrete Leveling is a method to level out cracked or sinking concrete slabs. It’s also an affordable alternative to complete slab replacement. It is more convenient, requires less disturbance and can be completed quickly.
If you’ve noticed cracks in your driveway or in other areas of your home, you may be thinking about replacing your slab. However, it is not always the best option. You could be spending 50 to 70 percent more than should you have leveling done. There are a variety of other advantages to concrete leveling.
It is simple to level your slab. It is essential to have the appropriate equipment. The task can be completed within one weekend. If you’re not confident handling the equipment yourself, you can hire a professional to do the job.
The first step is to make sure that there aren’t any gaps beneath the slab. These voids are usually caused by soil shifting and settling over the years. These voids can cause the slab’s surface to turn hollow or rock-like when it is removed. They can also cause water problems in your basement. In some instances the void that is under a slab can be filled with grout.
This product is available at your local home-based store. It is a mixture of Portland cement and polymer resinizers. It flows more easily than concrete and is pumped into place. You will need to mix the compound with a little water to form a thick cement-like slurry. Then, you can apply the compound by using a trowel or broom. The concrete will be raised by the slurry, and then returned to the original pour line.
If you’ve decided to attempt the process of leveling your slab, you can do so in a couple of hours. However, the timeframe of the process will be contingent on how large the area is. A small residential project will typically take just a few minutes. You might need to spend several days working on the commercial project.
Before you begin, check the concrete slab. If the surface is uneven, you’ll have to fill any holes created by the concrete. Also, you should check for obvious depressions in the surface. You can use a carpenter’s level to locate low points you didn’t notice. To mark the depression, you can draw a line with chalk. To grind the ridges at the extremes, you can use the concrete grinder.
After you’ve prepared your area then you can apply the primer. It is recommended to allow the primer to dry for at least 3 hours. This will ensure that the substance will stick to the surface and prevent bubbles from forming. After the primer has dried you can apply the leveling compound. If you are planning on walking on the floor you can walk on it within four hours. If you don’t want to, you can wait for another four hours. Your concrete will then be ready for you to walk on.
Comments are closed.